All of the articles in this proceedings volume have been presented at the 1st MIMSE 2022 on September 14th, 2022 in Mataram, Indonesia. These articles have been peer reviewed by the members of the Scientific Committee and approved by the Editor-in-Chief, who affirms that this document is a truthful description...

The Indonesian government targets Indonesia to have zero emission energy by 2050. Solar energy is one solution to this target. The issuance of the Minister of Energy and Mineral Resources Regulation Number 26 of 2021 concerning Rooftop Solar Power Plants opens up opportunities for increasing the capacity...

The current use of the gelam tree is only found in wood processing. On the other hand, gelam bark is not optimally utilized so as to produce unused bark waste even though the natural fiber of gelam bark is of high economic value. The purpose of this study was to determine the effect of volume variations...

Grains are agricultural products that often experience post-harvest damage, one of which is corn. Based on the standard SNI 014483–1998 quality requirements that must be met by corn is to have a moisture content of 14%. To maintain the quality and value of agricultural products, the drying method is...

This study investigates the impact toughness, tensile strength and morphology of the polyester matrix composite material reinforced with Musa acuminata stem fiber (MASF) and carboxyl terminated butadiene acrylonitryle (CTBN) filler. The fiber used was taken from the outer layer of the pseudo-stem banana...

When 2020 began the outbreak of new pneumonia, namely the coronavirus disease 2019 (COVID-19), alcohol suddenly became less available because it was the most sought-after item. This is because 70% alcohol can be used as an antiseptic and disinfectant solution to overcome coronavirus transmission. The...

Anodizing is one way of coating oxidation on aluminum, which is carried out by anodic oxidation at room temperature with the help of an electric current so that a chemical reaction occurs so that a layer is produced that can protect the metal from the effects of corrosion. The objective of this study...

This paper proposes development of a Pulse Width Modulation (PWM) scheme that overcomes the weakness of conventional Carrier-Based PWM (CBPWM) performance on Neural Point Clamp Inverter (NPC). This scheme uses the conventional CBPWM technique to developed Advanced CBPWM. This technique uses triangular...

The use of energy has helped the community a lot to meet their needs in various ways, one of which is the need for electrical energy for lighting, the use of electric tools to help work in the community, both in the government sector, the business world and industry. Abundant supply to be able to meet...

The effect of fuel variability in Thailand is that diesel fuel is one of the fuels affected by fuel variability. The use of alternative energy is an alternative to diesel engines. Therefore, this research is interested in studying the physicochemical properties of test fuels, engine efficiency, combustion...

One of the popular UAV applications in the logistics sector is the use of UAVs as couriers to deliver goods to customers’ homes. In this application, the UAV must be able to follow the given trajectory while avoiding the existing obstacles to get to the customer’s house. To fulfill this, UAVs require...

During the dry season, several areas in Indonesia experience drought. Communities in some areas have difficulty getting clean water. One solution to overcome this problem is to use a machine that produces water from the air. This machine works by utilizing the evaporator as a component to condense water...

The temperature of Photo-Voltaic (PV) cells which increases when getting high radiation levels during the mid-day can reduce the efficiency of PV cells. This is a detrimental characteristic of producing electrical energy in a solar power generation system. The study objective is to improve cooling techniques...

The investigation of flow behavior on the upper and lower surface airfoil was performed to know aerodynamic behaviors of airfoil in different Reynold Number. The more flexible simulation by using Computer Fluid Dynamic (CFD) has been used to analyze the behavior of flow which was addressed to application...

Power quality issues and drive performance under dynamic conditions are the major concern in traction. This paper proposes an active front-end converter (AFEC) fed 6-ϕ voltage source inverter (VSI) driven induction motor (IM) drive for traction. The AFEC at the 1-ϕ grid side and 6-ϕ VSI at the induction...

This study aims to determine the effect of adding the Silicon Carbide (SiC) to aluminum scrap on impact strength and microstructure using powder metallurgy (sintering) method. The materials used in this research are aluminum scrap and silicon carbide (SiC). There are three variations of the mixture,...

Hemodialysis is an artificial kidney replacement therapy that aims to control blood pressure and balance important minerals, such as potassium, sodium, and calcium, in the blood. The osmotic and ultrafiltration processes in the hemodialyzer were affected by the blood viscosity flowed through the permeable...

Amplifier is commonly used on signal processing. Class-A Amplifier is an amplification system which can amplify whole wave. Although it can amplify whole wave, it requires proper bias and collateral AC/DC load line. To set collateral AC/DC load line, Higher current through collector (IC) make better...

Indonesia is an archipelagic country which is divided into development corridors. The development corridor has been stipulated in the MP3EI development master plan, including Java Island. Java is the center of the country's development activities with nearly 60% of the population living on this...

Interval type-2 fuzzy (IT2F) model develops to substitute conventional control in power system (PS). The PS is operated to serve the consumer according to load demand. Load fluctuation on the PS is a real situation and can’t be avoided. The load fluctuation causes rotor oscillation on machine. Moreover,...

Unmanned Aerial Vehicle (UAV) Quadcopter has many functions and uses as logistics transportation with the advantages of transportability efficiency as a means of air transportation. Barriers to UAVs in carrying out their functions as air transportation are obstacles. UAV requires an automatic control...

This paper compares the performance of a condenser during the period between August and December 2018 to that during the commissioning period. It belongs to the Steam Power Plant (PLTU) I in Central Kalimantan. The comparisons are carried out in terms of the load, LMTD, temperature efficiency, capacity...

CO2 emissions are a global issue that many countries face. In handling this issue, one of them is by utilizing energy resources to cover CO2 emissions. However, among the many methods used to absorb CO2, one of the most effective is a process by injecting CO2 into the earth layer that also known as carbon...

Fossil fuel consumption continues to increase every year and the possibility to find new reserves will be increasingly difficult. It can be estimated that if the current rate of consumption and production continues, oil reserves will be depleted in 50 years. The increasing difficulty in finding new oil...

Oil and gas are energy sources that experience the fastest growth among other energy sources. The oil recovery process can be divided into three recovery stages, namely primary oil recovery, secondary recovery and tertiary recovery or commonly called Enhanced oil recovery (EOR). Enhanced oil recovery...

Co-firing is a combustion system that involves two or more types of fuel in one combustion chamber. The abundant availability of biomass and the depletion of availability are the background for this co-firing. This study aims to determine the optimum composition of coal and biomass and to optimize the...

This research presents the implementation of the Linear Quadratic Gaussian (LQG) Controller and LiDAR sensors on the quadcopter used to avoid obstacles. The LQG controller is a combination of a Linear Quadratic Regulator (LQR) with a Kalman Filter as a State Estimator. The results of the estimate by...

Due to their abundance and environmental friendliness, Paederia foetida stem fiber (PFs) are an interesting material to develop as a substitute for glass fiber. The goal of this research is to provide a thorough understanding of the physical, chemical, and functional properties of PFs. The PFs were treated...

Manual work in small medium enterprises involves a lot of repetitive activities that have potential to result in high musculoskeletal disorder. This study was conducted at PT ASM, a small industry that produces electrical spare parts with a make to order system using manual tapping machine operated by...

PT XYZ is a manufacturing company that produces packaged plastic bottles. Every month the company produces millions of packaged plastic bottles with various shapes and colors. The problem that still occurs today is the ineffectiveness of engine performance. This company has implemented Overall Equipment...

The study investigated the effects of ageing on the fracture toughness of the nano Calcium Carbonate/ground rubber particle hybrid composites. The rubber particles content was 0, 5, 10 and 15 wt%, while the calcium carbonate contents was fixed 2 wt% of the epoxy resin. Aging was carried out in distilled...

Conventional grid has limited power generation resources. Therefore, we need an architecture which fulfil the power demand of the users and can restricts the excess use of power beyond the limit. Since the past few years, smart grid has become a better architecture as it can manage the crucial part of...