The Simulation Analysis of Springback during High-pressure Water Jet Forming for Small Curvature workpiece

DOI

10.2991/icmse-15.2015.252How to use a DOI?

Keywords

small curvature workpiece; water jet forming; springback; analysis

Abstract

Most of the aircraft skin parts are with small curvature and the most difficult problem is the controlling of springback. In this paper, the comparison for springback between high-pressure water jet forming and stamp forming is presented by using software ABAQUS. The springback of the high-pressure water jet forming is smaller than stamp forming. It is concluded by using software ABAQUS that between the springback during high-pressure water jet forming and interlayer distance is linear, and as the feed rate increases before the feed speed reaches 750 mm/min, then can’t change basically, which have important reference and practical value to improve the springback of during high-pressure water jet forming for small curvature workpiece.

Copyright

© 2015, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Lingyun Zhang
AU  - Zhiqiang Li
AU  - Anliang Wang
PY  - 2015/12
DA  - 2015/12
TI  - The Simulation Analysis of Springback during High-pressure Water Jet Forming for Small Curvature workpiece
BT  - Proceedings of the 2015 6th International Conference on Manufacturing Science and Engineering
PB  - Atlantis Press
SP  - 1394
EP  - 1398
SN  - 2352-5401
UR  - https://doi.org/10.2991/icmse-15.2015.252
DO  - 10.2991/icmse-15.2015.252
ID  - Zhang2015/12
ER  -