Proceedings of the 2nd International Conference on Electronic & Mechanical Engineering and Information Technology (EMEIT 2012)

<Previous Article In Volume
Next Article In Volume>

The effects of machining parameters on machining time in piezoelectric self-adaptive micro-EDM

Authors
Xiuzhuo Fu, Liying Gao, Qinhe Zhang
Corresponding Author
Xiuzhuo Fu
Available Online September 2012.
DOI
10.2991/emeit.2012.247How to use a DOI?
Keywords
Micro-EDM, Self-adaptive, Piezoelectric actuator, machining time
Abstract

A new piezoelectric self-adaptive micro electrical discharge machining system, based on inverse piezoelectric effect, was developed in this paper to improve stability of micro-EDM process The Working mechanism and working process of this new technology were illustrated. In this new technology, the piezoelectric actuator was used as the micro driven system to control the discharge gap distance depending on the discharge state. This paper presents an investigation on the effects of machining parameters on machining efficiency in piezoelectric self-adaptive discharge machining. The effects of machining parameters such as open voltage, capacitance, resistance, spindle rotational speed and initial feed speed have been analyzed on machining efficiency by using signal to noise analysis method based on orthogonal experiment.

Copyright
© 2012, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

<Previous Article In Volume
Next Article In Volume>
Volume Title
Proceedings of the 2nd International Conference on Electronic & Mechanical Engineering and Information Technology (EMEIT 2012)
Series
Advances in Intelligent Systems Research
Publication Date
September 2012
ISBN
978-90-78677-60-4
ISSN
1951-6851
DOI
10.2991/emeit.2012.247How to use a DOI?
Copyright
© 2012, the Authors. Published by Atlantis Press.
Open Access
This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Cite this article

risenwbib
TY  - CONF
AU  - Xiuzhuo Fu
AU  - Liying Gao
AU  - Qinhe Zhang
PY  - 2012/09
DA  - 2012/09
TI  - The effects of machining parameters on machining time in piezoelectric self-adaptive micro-EDM
BT  - Proceedings of the 2nd International Conference on Electronic & Mechanical Engineering and Information Technology (EMEIT 2012)
PB  - Atlantis Press
SP  - 1133
EP  - 1137
SN  - 1951-6851
UR  - https://doi.org/10.2991/emeit.2012.247
DO  - 10.2991/emeit.2012.247
ID  - Fu2012/09
ER  -