Research on the Angle of Flaring Angle of One Way Valve

DOI

10.2991/meici-17.2017.35How to use a DOI?

Keywords

Airborne pod; One-way valve; Shaft; Flaring; Angle of extension

Abstract

The one-way valve of a certain type of airborne pod is discussed in detail; especially a lot of people are concerned about expanding process of shaft. It can not only provide the basis for the optimization design and manufacture of the product, at the same time it also can improve the structure process of this type of airborne pod. The processing mode of the original shaft end is flared when the crack is apt to appear. Therefore, the research on machining angle is very necessary. Firstly, a great deal of aspects of personnel injury sampling one-way valve shaft, and then do some tests on these samples. When determining the material properties of them, the limit expansion angles of shaft were decided by these data, and they can influence the decision process factors. In order to realize the optimization of the one-way valve shaft hole, the researchers provide the basis for determining the optimal structure of the fixtures.

Copyright

© 2017, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Yang Wang
AU  - Dongfang Hu
PY  - 2017/10
DA  - 2017/10
TI  - Research on the Angle of Flaring Angle of One Way Valve
BT  - Proceedings of the 7th International Conference on Management, Education, Information and Control (MEICI 2017)
PB  - Atlantis Press
SP  - 159
EP  - 167
SN  - 1951-6851
UR  - https://doi.org/10.2991/meici-17.2017.35
DO  - 10.2991/meici-17.2017.35
ID  - Wang2017/10
ER  -