Design and Realization of Distribution Static Synchronous Compensator

DOI

10.2991/meic-14.2014.38How to use a DOI?

Keywords

STATCOM; DSP; hardware design; voltage compensation; reactive power

Abstract

According to the engineering requirement of power distribution network reactive power compensation, the paper presents a software and hardware design method of the STATCOM based on DSP. In order to stabilize the PCC voltage around a prescribed value in the direct current control mode, the three-level converter of three phase bridge of the equipment in main circuit was connected to power net with coupling transformer. The paper mainly introduced the development of STATCOM device controller based on DSP(TMS320F2812) and presents the detailed design methods of DSP controller such as signal conditioning circuit, synchronous detection circuit, driving circuit of IPM. At the same time, the paper presents the software function module of STATCOM system. The STATCOM based on such method has been applied in an experimental flat roof.The detecting results of STATCOM for voltage compensation show that the design STATCOM meet the voltage compensation requirements, and the reactive power compensation effect is obvious, and proved the correctness and feasibility of the device

Copyright

© 2014, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Linsuo Zeng
AU  - Feng Chen
PY  - 2014/11
DA  - 2014/11
TI  - Design and Realization of Distribution Static Synchronous Compensator
BT  - Proceedings of the 2014 International Conference on Mechatronics, Electronic, Industrial and Control Engineering
PB  - Atlantis Press
SP  - 170
EP  - 173
SN  - 2352-5401
UR  - https://doi.org/10.2991/meic-14.2014.38
DO  - 10.2991/meic-14.2014.38
ID  - Zeng2014/11
ER  -