Investigation of Machining Energy in Wire Electrical Discharge Machining Using Measurement of Deform

DOI

10.2991/mcei-16.2016.246How to use a DOI?

Keywords

Machining energy; Electrical discharge machining; Deform

Abstract

This paper aims at investigating the machining energy in wire electrical discharge machining. The open kerf was designed on raw martial block to obverse deform resulted from the discharge machining, and the deform on the material block was measured. The density of energy distribution was different along the kerf, which results in the inhomogeneity deform and ever more frequent breakage of wire. This finding proved the rule which the hole for wire must be drilled before machining must be complied with.

Copyright

© 2017, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Quanli Han
PY  - 2016/12
DA  - 2016/12
TI  - Investigation of Machining Energy in Wire Electrical Discharge Machining Using Measurement of Deform
BT  - Proceedings of the 2016 6th International Conference on Mechatronics, Computer and Education Informationization (MCEI 2016)
PB  - Atlantis Press
SP  - 1196
EP  - 1199
SN  - 1951-6851
UR  - https://doi.org/10.2991/mcei-16.2016.246
DO  - 10.2991/mcei-16.2016.246
ID  - Han2016/12
ER  -