Analysis and Research on Broken-off Driving Bevel Gear shaft of Automobile Axle

DOI

10.2991/jimet-15.2015.217How to use a DOI?

Keywords

automobile axle; driving bevel gear; broken; annealing

Abstract

Based on the phenomenon of broken in the running process of the drive Gear shaft of Automobile Axle. It was found that the major site of broken for thread and spline connected region. The process of the gear shaft and the shaft material of the broken and the structure of thread and spline connected region were analyzed. Finally, it was found that the annealing time of thread and the structure of thread and spline connected region have some problems. The structure of thread and spline connected region was optimized. After improvement, it was not occurred the phenomenon of broken in the running process of the drive Gear shaft of Automobile Axle.

Copyright

© 2015, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Zhanlong Cao
PY  - 2015/12
DA  - 2015/12
TI  - Analysis and Research on Broken-off Driving Bevel Gear shaft of Automobile Axle
BT  - Proceedings of the 2015 Joint International Mechanical, Electronic and Information Technology Conference
PB  - Atlantis Press
SP  - 1151
EP  - 1154
SN  - 2352-538X
UR  - https://doi.org/10.2991/jimet-15.2015.217
DO  - 10.2991/jimet-15.2015.217
ID  - Cao2015/12
ER  -