Prototype of Heat Exchanger U-Tube Model Shell and Tube Counter Flow

DOI

10.2991/icst-18.2018.188How to use a DOI?

Keywords

Heat Exchanger, Counter Flow , U- Tube, Fluids, Cooler, Flowrate

Abstract

This research aimed to discuss the manufacturing of The Heat Exchanger Cooler Type U-Tube with 2 types of fluid, water as cold fluid and oil as hot fluid, which flew in opposite direction. There were 2 methods which used in this research, the empirical method and the experimental method. The empirical method used some formulas to find out the impact of using U-Tube as a heat exchanger, while the experimental method used by taking data in real time. There were 2 different pumps used in this heat exchanger, water pump and oil pump. The average oil pump flow rate was about 9.64 L/min and the temperature was about 95.17℃. On the other hand, the average water pump flow rate was about 30.42 L/min and the temperature was about 30.50℃. The material of tubes was made of a copper tube which had 4mm inner inlet diameter and 6mm outer inlet diameter. There was 31 U shaped copper tubes in total which had 1000mm length for each. Based on the experimental method, it was proved that this type of heat exchanger made 58.83% of temperature dropped.

Copyright

© 2018, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Hairil Budiarto
AU  - Faikul Umam
PY  - 2018/12
DA  - 2018/12
TI  - Prototype of Heat Exchanger U-Tube Model Shell and Tube Counter Flow
BT  - Proceedings of the International Conference on Science and Technology (ICST 2018)
PB  - Atlantis Press
SP  - 934
EP  - 939
SN  - 2589-4943
UR  - https://doi.org/10.2991/icst-18.2018.188
DO  - 10.2991/icst-18.2018.188
ID  - Budiarto2018/12
ER  -