Study on the residual stress of bar with straightening by two rolls
- DOI
- 10.2991/icsma-16.2016.40How to use a DOI?
- Keywords
- residual stress; straightening; bar; 42CrMo; finite element method
- Abstract
The 42CrMo bar has been widely used for its outstanding mechanical performance. Before bar leaves rolling factory, the straightening process should be used to keep bar's straightness. However, the residual stress is also generated simultaneously, which largely affects the bar in using. In this article, the residual stress of 42CrMo bar with two roll straightening process was studied by finite element method. The results show that, after the straightening process, the compressive stress and tensile stress were generated on bar's surface and center, respectively. Meanwhile, the bar's neutral layer was migrated. The bar's residual stress was tested with hole-drilling technology. The comparison between the simulation and test results has been proved the validity of the finite element analysis. The results and methods proposed here is the basis of optimizing straightening process.
- Copyright
- © 2016, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Yufeng Wang AU - Junkai Fan AU - Cai Liu PY - 2016/12 DA - 2016/12 TI - Study on the residual stress of bar with straightening by two rolls BT - Proceedings of the 2016 4th International Conference on Sensors, Mechatronics and Automation (ICSMA 2016) PB - Atlantis Press SP - 217 EP - 222 SN - 1951-6851 UR - https://doi.org/10.2991/icsma-16.2016.40 DO - 10.2991/icsma-16.2016.40 ID - Wang2016/12 ER -