Design and Development of Training System for Teaching on Shaft Furnace Mechatronics
Authors
Ye Sun, Ren Chen, Zuoliang Zhang, Meng Li, Yan Liu, Mingxia Feng, Huishu Zhang, Yan Cui
Corresponding Author
Ye Sun
Available Online January 2016.
- DOI
- 10.2991/icaita-16.2016.37How to use a DOI?
- Keywords
- shaft furnace; Mechantronics system; PLC control system
- Abstract
Based on the practical teaching requirements of metallurgical engineering, a cold position training device on the shaft furnace was designed in line with actual production. The control system adopts the integrated control cabinet and its design of the training device is implemented by the PLC of Siemens S7-300 and the configuration software of Real Bridge. The control mode includes two kinds of modes, which are remote control and manual control. Through the development and use of the shaft furnace training devices, the teaching content can be visualized. This device has been put into use in colleges, and obtained the good training effect.
- Copyright
- © 2016, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - Ye Sun AU - Ren Chen AU - Zuoliang Zhang AU - Meng Li AU - Yan Liu AU - Mingxia Feng AU - Huishu Zhang AU - Yan Cui PY - 2016/01 DA - 2016/01 TI - Design and Development of Training System for Teaching on Shaft Furnace Mechatronics BT - Proceedings of the 2016 International Conference on Artificial Intelligence: Technologies and Applications PB - Atlantis Press SP - 146 EP - 148 SN - 1951-6851 UR - https://doi.org/10.2991/icaita-16.2016.37 DO - 10.2991/icaita-16.2016.37 ID - Sun2016/01 ER -