Analysis and Solution of the Crack of the Outer Plate of the Door

DOI

10.2991/ame-16.2016.196How to use a DOI?

Keywords

Automobile panel, Door outer panel, Drawing die, Technology, Wrinkle, Crack.

Abstract

The stretching process is a complex plastic deformation process, the deformation zone is relatively large, metal flow, in the process of drawing prone to flange wrinkling and force transferring area of tensile deformation to scrap parts. Therefore, it is necessary to analyze the wrinkle, the root cause of the tension, in tool design and manufacture of stamping process should be attention, to improve drawing quality. The quality and the cost of the car body is very much, in the mold development stage is basically determined. This stage of product plan, process plan, mold preparation, etc., it has decided the cost of the mold, stamping parts material utilization, production efficiency, stamping parts quality, so in the body parts stamping die development stage for effective cost control and quality management is very necessary.

Copyright

© 2016, the Authors. Published by Atlantis Press.

Open Access

This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).

Download article (PDF)

TY  - CONF
AU  - Hua-Gang Liu
AU  - Rui-Can Hao
AU  - Zhi-Xin Feng
PY  - 2016/06
DA  - 2016/06
TI  - Analysis and Solution of the Crack of the Outer Plate of the Door
BT  - Proceedings of the 2nd Annual International Conference on Advanced Material Engineering (AME 2016)
PB  - Atlantis Press
SP  - 1201
EP  - 1204
SN  - 2352-5401
UR  - https://doi.org/10.2991/ame-16.2016.196
DO  - 10.2991/ame-16.2016.196
ID  - Liu2016/06
ER  -