Modelling Element of Chips in Rotary Milling by Experiment Planning Method
Authors
V.G. Shalamov, S.D. Smetanin, A.V. Plaksin
Corresponding Author
V.G. Shalamov
Available Online April 2018.
- DOI
- 10.2991/aime-18.2018.110How to use a DOI?
- Keywords
- rotary milling, chips, modelling, experimental planning method
- Abstract
Investigation results of modeling the influence of different parameters on the chip element length in rotary milling are presented. To highlight the significantly influencing factors, we used Plackett-Berman’s plans. Evaluation of the adequacy of the regression equation was carried out according to the Fisher criterion. As a result, an adequate empirical mathematical model for determining the length of the chip element in the form of an algebraic polynomial is obtained
- Copyright
- © 2018, the Authors. Published by Atlantis Press.
- Open Access
- This is an open access article distributed under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Cite this article
TY - CONF AU - V.G. Shalamov AU - S.D. Smetanin AU - A.V. Plaksin PY - 2018/04 DA - 2018/04 TI - Modelling Element of Chips in Rotary Milling by Experiment Planning Method BT - Proceedings of the International Conference "Actual Issues of Mechanical Engineering" (AIME 2018) PB - Atlantis Press SP - 574 EP - 578 SN - 2352-5401 UR - https://doi.org/10.2991/aime-18.2018.110 DO - 10.2991/aime-18.2018.110 ID - Shalamov2018/04 ER -